Prepare a Windows startup disk before you begin. This will be a necessary part of the process. It will also be useful in an emergency. The procedure below assumes that you have installed the new hard drive correctly, and that it is set up as the slave drive i. See the documentation that came with your new hard drive for instructions on how to install and configure the drive physically.
Note: New hard drives will often come with disk management software. The first hard drive should be set up as master.
Consult your hard drive documentation about the jumper settings. Drives can be configured as master, slave, or only drive. If a drive occupies an IDE channel by itself some computers can have more than one IDE channel , it should be set up as an only drive. If there are two drives on an IDE channel, one must be set as master, the other as slave.
Only the master can be the boot disk. You must tell the computer that a new hard drive has been added. In most cases, as the computer boots, it will prompt you to press a certain key or key combination to get into the CMOS. Upon starting the computer, press the appropriate key when prompted to enter the CMOS setup program. All of them have a screen where you can set drive parameters. Most current CMOS setup programs can auto-detect the hard drive's geometry, so you usually will not have to input the drive parameters cylinders, heads, and sectors.
If you are installing a drive larger than MB, make sure that LBA or Large mode is turned on before you do the auto-detect. You may not have to set this option on newer computers. The following equipment will be needed to produce a signal capable of being digitised in your PC: a turntable and pickup arm fitted with a good … [Read More Digital TV For years, the broadcasting and computer industries have proclaimed that "convergence" was just around the … [Read More A warning that all data on your C: drive will be lost is displayed.
Format then prints a number of statistics, including the number of bytes comprising the total disk space, the number of bytes used by the system and the number of available bytes, culminating with a Volume Serial Number. If you're in Windows or files on the hard drive are in use, this command will not work. If you want to format the primary hard drive, you'll need to boot from a bootable diskette , restore disc , or another bootable drive. Tip Although the information appears to be erased, it is still possible for software recovery programs to recover information from a formatted drive.
Availability Format syntax Format examples. Windows 10 and Windows 11 syntax. Windows Vista, Windows 7, and Windows 8 syntax. Microsoft Windows and Windows XP syntax. Microsoft Windows 95, 98, ME syntax. Caution When using the format command, remember all the information on the drive you want to format will be erased entirely.
Note If you're in Windows or files on the hard drive are in use, this command will not work. Related information How to erase my hard drive and start over. How do I format a floppy diskette? Forces the volume to dismount first if necessary. All opened handles to the volume would no longer be valid.
0コメント